Valspa Concrete and Masonry Natural Look Protective Seale

Exterior aggregate, concrete, brick, pavers, masonry, mortar and flagstone. Do not use on garage floors.

All surfaces must be clean, dry and free of all loose, peeling paint or contaminants. Bare concrete: New concrete, masonry surfaces and mortar should be cured 60 days. Previously sealed surfaces: Clean with an all-purpose cleaner (TSP or substitute). Previously sealed surfaces must be porous and able to accept additional sealer. Test surface porosity before sealing: Avoid using this product on nonporous, sealed surfaces. To test, place a few drops of water on the surface. If water sinks in, the surface is porous enough to use this finish. If water remains on the surface, do not use.

Use a roller or low-pressure, garden-type sprayer. While the first coat is still wet, apply a second coat to maximize protection. Allow 5–10 minutes for final penetration, then use a clean, dry cloth to wipe off all excess that did not soak into the surface. Do not pond or puddle this product.

Dry Time @ 77 °F and 50 % Relative Humidity
To The Touch: 1 hour 1 hour
Recoat: N/A

Clean up with warm, soapy water.